N-907-558-02 Genuine VW/Audi Bumper Impact Absorber Bolt with Washer - M8 x 32

Genuine VW/Audi bumper impact absorber bolt with washer, part number N-907-558-02. This original fastener secures the assigned front bumper impact absorber to the core support. It is supplied individually for replacement of missing or damaged mounting hardware.

Technical details

• Original number: N-907-558-02 / N90755802.
• Published nominal size: M8 x 32.
• External hex head with the pictured broad washer arrangement.
• Original connection: bumper impact absorber to core support.
• Six required for the assigned assembly; one bolt supplied.
• This listing supplies the small mounting bolt. Impact absorber, bumper components and support parts are separate.

The bolt clamps the specified absorber mounting connection against its intended attachment surface. Correct engagement and bearing contact matter to the assembly. A similar-looking bolt can have a different length, washer arrangement or assigned location.

This fastener is separate from the long impact-beam securing bolts and bumper cover screws. Confirm the original number at the absorber-to-core-support connection before choosing replacement hardware.

Common reasons to replace

Replace missing hardware, damaged threads, a rounded hex head, deformation or corrosion that compromises reliable installation. Inspect hardware exposed during support or absorber service and renew it wherever required by the factory repair procedure.

A damaged front mounting assembly requires inspection of the absorber, core support, mounting holes and surrounding components. A new bolt cannot repair bent structure, a cracked mounting part or damaged receiving threads.

Incorrect fasteners found after earlier service should be corrected only after the original attachment arrangement is verified. Match the specified hardware rather than selecting a replacement solely by thread diameter or visual similarity.

Installation and service notes

Follow the factory procedure for the exact front absorber and core-support arrangement. Support the components as required before disconnecting their attachments. Inspect the mounting surfaces and alignment before installing replacement hardware.

Confirm the original bolt number, nominal size and washer arrangement. Start the bolt by hand into sound threads without cross-threading. Do not use the fastener to pull damaged or misaligned mounting parts into position.

Use the correct hex socket fully seated on the head. Apply the factory tightening sequence and torque or angle requirement for this exact connection. Do not transfer a tightening value from a bumper cover screw, impact-beam bolt or unrelated M8 fastener.

Follow the prescribed thread preparation and hardware renewal requirements. Replace any additional mounting parts identified by the procedure. Do not add washers or thread treatments unless required by the original service instructions.

Inspect all hardware in the serviced connection and order the quantity needed for the actual repair. This listing supplies one bolt with its pictured washer arrangement rather than a six-piece vehicle kit.

After assembly, complete the required attachment, alignment and surrounding-component checks. If a bolt fails to seat normally or the connection remains loose, inspect the receiver and mounting parts before tightening further.

Fitment

Confirm N90755802 at the absorber-to-core-support connection. One bolt supplied.