TPU Glossy Full Front Car Paint Protection Film (PPF) for Tesla Model 3

TPU Glossy Full Front Paint Protection Film for Tesla Model 3

Protect the most exposed painted surfaces at the front of your Tesla Model 3 with a vehicle-specific pre-cut TPU paint protection film kit. The clear high-gloss film covers the hood, front bumper, front fenders and side mirror caps while preserving the appearance of the original paint.

Full Front Coverage Areas

⚠️ Headlights & A-Pillars Are Not Included

Tesery states that the standard Full Front kit covers the hood, front bumper, front fenders and side mirror caps. Headlights and A-pillar sections are not included unless specifically listed in a selected package.

Pre-Cut Piece Count

TPU Material Performance

Everyday Paint Protection

Road Debris
The TPU layer helps absorb light surface impacts from common road debris before they reach the painted surface underneath.

Wash Swirls & Fine Marks
The film creates a sacrificial outer layer that helps reduce direct contact with the factory paint during normal use and washing.

Environmental Exposure
The protective film also helps isolate the covered paint from common contaminants such as bug residue and bird droppings until they can be cleaned away.

⚠️ PPF Does Not Prevent Every Type of Damage

Paint protection film can help reduce common cosmetic paint damage, but it cannot prevent dents, severe impacts, deep cuts, punctures or every form of paint damage.

Heat-Activated Self-Healing Topcoat

Tesery states that warmth from sunlight or controlled heat can help the topcoat recover from minor surface marks. Deep scratches, cuts, punctures and damage through the film will not self-heal.

Vehicle Compatibility

⚠️ Select the Exact Model 3 Version

The front bumper and body-panel geometry differs between Model 3 generations and trims. Choose the exact vehicle version shown in the selector rather than ordering only by the “Model 3” name.

Wet Installation Overview

1. Prepare the Paint
Wash the panel thoroughly and remove bonded contamination. Tesery specifically recommends using a clay bar during preparation.

2. Apply Slip Solution
Spray an appropriate slip solution onto the painted panel and the adhesive side of the film.

3. Lay the Pre-Cut Film
Place the PPF onto the wet surface and align the pre-cut pattern without stretching it aggressively into position.

4. Tack the Reference Points
Align the edges, corners and major reference points before fully setting the film.

5. Squeegee the Film
Push slip solution and trapped air outward with overlapping squeegee strokes while maintaining alignment.

6. Allow the Film to Cure
Keep the vehicle dry and allow the PPF to settle for at least 8–12 hours after installation.

⚠️ Professional Installation Recommended

Experienced DIY installers may install pre-cut PPF using wet-installation techniques, but Tesery recommends professional installation—especially for the front bumper and other complex curved sections.

⚠️ Pre-Cut Does Not Mean Zero Installation Skill

The vehicle-specific patterns reduce the need for trimming directly on the car, but correct paint preparation, slip solution, stretching, alignment and squeegee technique are still required for a clean result.

Specifications

Package Includes

Pre-Cut TPU PPF for:
Full Hood
Front Bumper
Left Front Fender
Right Front Fender
Side Mirror Caps

Installation Tool Kit

Quick Answers